Magna Shine Paint Correction Mitt

The Magna Shine Paint Correction Mitt works quickly and safely to remove bonded contaminants from your paint, glass, trim moldings and plastics. The new, advanced rubber polymer technology is more effective than a traditional clay bar. You will be amazed at how simple it is to remove surface level and above contaminants that have bonded to your vehicle's exterior surfaces.

Safely and easily remove light tree sap, tar, scuff marks, water mark residue, rail dust, road grime, bugs, paint overspray and other extra surface contaminants. Once finished, your paint will look and feel remarkably clean, preparing it for polishing or application of your favorite wax or sealant.

Cleaning your Magna Shine Paint Correction Mitt couldn't be easier! No more picking out large contaminants and constantly kneading your clay bar. With the Magna Shine Paint Correction Mitt all you have to do is rinse with clean water after each section and you'll be ready to use it again. 

How to use your Magna Shine Paint Correction Mitt:

1. Thoroughly wash the vehicle to free it of dust, sand and dirt. Also, make sure any tar and grease is removed prior to application.
2. The surfaces should be cool to the touch.
3. Mist a sufficient lubricant onto the surface evenly and polish the surface with light pressure. Make sure to use a lubricant and not plain water. Plain water does not make an adequate lubricant.
4. Wipe off any remaining residue on the paint with a clean dry microfiber towel.
5. After each section is completed, clean your mitt by simply rinsing it with water.
6. Repeat steps 2-4 until you have completed the vehicle.

Your Magna Shine Paint Correction Mitt has a protective coating to ensure stability during transportation. Prior to using it for the first time, break-in the towel following these simple instructions.

1. Moisten the mitt with your lubricant.
2. Moisten a portion of window glass or other glass surface.
3. Rub the mitt in a circular motion against the glass for 30 to 60 seconds. You may see a white soapy foam. This is the protective coating coming off.
4. Don't use on paint until the polymerized rubber is soft and slightly tacky.

Mitt Size: 6 in. x 8 in.